Salt Stack: Using Execution Modules In Sls

So far as I can see in the Salt documentation (e.g. here) there are two main types of modules supported: state modules and execution modules (I know there're also renderers, return

Solution 1:

You are correct that there are significant differences between execution modules and state modules. Unfortunately the term module is a bit overloaded.

An execution module is a command sent to a Salt Minion to be executed immediately. Examples are "install apache" or "restart memcached".

A state module tells the Salt Minion what the end result, or "state" should be. Examples would be "make sure apache is installed" or "make sure this specific config file exists on the filesystem". The important difference is that a state module will check the system to see if the machine conforms with the desired state before doing anything. So in the case of "make sure apache is installed" the Salt Minion will check to see if Apache is installed and do nothing if Apache is installed. If it's not obvious, Salt will install Apache if needed.

Now to accomplish restarting the selenium-node like you noted in your question you'll want to have your service watch something; usually a package change and/or config change. That way Selenium will only restart when needed. Here's a rough example. I'm not familiar with installation of selenium-node so please consider the following sls file an example. I'm assuming selenium-node can be installed from your system's package repo.

cat/srv/salt/selenium-node.slsselenium-node:pkg:-installedservice:-running-watch:-pkg:selenium-node-file:/etc/selenium-node.conffile:-managed-name:/etc/selenium-node.conf-source:salt://selenium/selenium-node.conf# assuming config located at /srv/salt/selenium/selenium-node.conf  on the Salt Master

Here we have 3 states under the "selenium-node" ID Declaration. We're managing the system package, the service and a config file. You'll notice that the service is watching both the selenium-node package and the config file. When a service is watching something the service will restart, by default, when the "watched" thing reports a change.

This is generally how you want to handle causing a service restart when using Salt States. This way the service will only get restarted when needed. This helps your Salt States be idempotent and only cause changes to your system when actually needed.

Now, to answer the second part of your question. Yes, it is possible to run an execution module from within a state or sls file. You can accomplish this through the "module.run" state. Docs are here: http://docs.saltstack.com/ref/states/all/salt.states.module.html#module-salt.states.module

Here's how you would cause your service to restart every time you run this state or sls file:

cat /srv/salt/selenium/selenium-restart.sls

restart_selenium:module.run:
    - name: service.restart
    - m_name: selenium-node   # m_name gets passed to the execution moduleas"name"